Introduction: A novel ablation catheter that can measure local impedance (LI) was recently launched. We aimed to explore target LI measurements at each radiofrequency application (RFA) for creating sufficient ablation lesions during pulmonary vein (PV) isolation. Methods: This prospective study included 15 consecutive patients scheduled to undergo an initial ablation of paroxysmal atrial fibrillation (AF). Circumferential ablation around both ipsilateral PVs was performed using a 4-mm irrigated ablation catheter with an LI sensor. Point-by-point ablation was used with a 4-mm inter-ablation-point distance. Operators were blinded to LI measurements during the procedure. Creation of sufficient ablation lesions was assessed by the absence of a conduction gap. Results: After first-pass encircling PV antrum ablation, left atrium to PV conduction remained in 12 of 30 (40%) ipsilateral PVs. Mapping using the mini-basket catheter identified 48 ablation points through which the propagation wave entered the PV. At ablation points with a gap, the LI drop during RFA was half that at points without a gap (12 ± 7 vs. 23 ± 12 ohm, p<0.001). The GI drop did not differ between ablation points with and without a gap (12 ± 7 vs. 14 ± 10 ohm, p=0.10). An LI drop of 15 ohm predicted sufficient lesion formation without a gap with a sensitivity of 0.71, specificity of 0.81, and predictive accuracy of 0.75. Conclusion: A target LI drop of 15 ohm at each RFA with a 4-mm distance between adjacent ablation points may facilitate creation of sufficient ablation lesions during PV isolation