AUTHOREA
Log in
Sign Up
Browse Preprints
LOG IN
SIGN UP
Essential Site Maintenance
: Authorea-powered sites will be updated circa 15:00-17:00 Eastern on Tuesday 5 November.
There should be no interruption to normal services, but please contact us at
[email protected]
in case you face any issues.
Yuyang Liu
Public Documents
2
Interfacial Fracture Toughness Measurement of Welded Babbitt alloy SnSb11Cu6/ 20Steel
Yuepeng Gao
and 2 more
March 03, 2021
The interface fracture toughness of SnSb11Cu6/20steel was measured by calculating the critical energy release rate and stress phase angle of the interface crack. A three-point bending test was used to introduce cracks into the bonding interface, and the cohesion model of the bonding interface was established through experimental data. Through finite element analysis of load-deflection curves with and without interface crack propagation, the crack initiation point is found. Then the energy calculation model of crack propagation is established, and the critical energy release rate is obtained using the virtual crack growth criterion. The calculation results of the stress phase angle show that the crack propagation is greatly affected by the normal stress after the babbitt alloy layer fractures. If the strength of the substrate material is weaker, the crack will continue to expand in the tangent perpendicular to the crack tip.
Interfacial Fracture Toughness Measurement of New Composite Material SnSb11Cu6/ 20Ste...
Yuepeng Gao
and 2 more
November 05, 2020
The interface fracture toughness test of SnSb11Cu6/20steel is realized by three-point bending experimental technique, interfacial cracks are introduced through the overall bending of the composite panel, and the critical energy release rate of 12.07×103 J/m2 is obtained by calculating the energy released per unit area at the fracture interface. To characterize the stress state of the crack tip, the stress phase angle of the crack tip is calculated using finite element analysis(FEA). At the same time, five sets of FEA experiments are specifically set up to determine the magnitude of the effect of changes in the interface fracture critical load values on the critical energy release rate. The results show that the change in the critical load value affects the critical energy release rate by only 0.08%. And the characterization of the crack tip stress state reveals that the relative strength of the shear stress that drives the interfacial cracking is weaker than that of the positive stress after the crack propagates to a certain length under bending conditions, which also implies that the positive stress is the main reason that drives the interfacial crack to continue propagating when the composite layer is completely fractured.