AUTHOREA
Log in
Sign Up
Browse Preprints
LOG IN
SIGN UP
Essential Site Maintenance
: Authorea-powered sites will be updated circa 15:00-17:00 Eastern on Tuesday 5 November.
There should be no interruption to normal services, but please contact us at
[email protected]
in case you face any issues.
John van der Schaaf
Public Documents
1
Mass transfer in 3D printed electrolyzers: The importance of inlet effects
Stéphane Weusten
and 3 more
December 30, 2020
This paper investigates the effect of inlet shape, entrance length and turbulence promoters on mass transfer by using 3D printed electrolyzers. Our results show that the inlet design can promote turbulence and lead to an earlier transition to turbulent flow. The Reynolds number at which the transition occurs can be predicted by the ratio of the cross-sectional area of the inlet to the cross-sectional area of the electrolyzer channel. A longer entrance length results in more laminar behavior and a later transition to turbulent flow. With an entrance length of 550mm, the inlet design did no longer affect the mass transfer performance significantly. The addition of gyroid type turbulence promoters resulted in a factor 2 to 4 increase in mass transfer depending on inlet design, entrance length and the type of promoter. From one configuration to another, there was a minimal variation in pressure drop (<16 mbar).