loading page

Steel fiber bond strength to estimate fRi parameters
  • Jeandry Bule Ntuku,
  • Aaron Kadima,
  • Dênio Ramam Carvalho de Oliveira
Jeandry Bule Ntuku
Universidade Federal do Pará
Author Profile
Aaron Kadima
Universidade Federal do Pará

Corresponding Author:[email protected]

Author Profile
Dênio Ramam Carvalho de Oliveira
Universidade Federal do Pará
Author Profile

Abstract

This paper presents the results of the safety assessment of the β coefficient that correlates the residual flexural tensile strength parameters fRi (i = 1, 2, 3, and 4) in steel fiber reinforced concrete (SFRC), collected through experimental notched beam flexural tests in three points, according to the fib Model Code 2010 (fib, 2013), with the bond strength (fu,f) of the hook-end type steel fiber in the concrete mix. The SFRC beams were chosen, which presents the load-opening ratio curve of the crack, F-CMOD (Crack Mouth Opening Displacement) in softening behavior, the compressive strength of the concrete, 25 MPa < fc < 80 MPa, the fiber volume content, 0.25 % < Vf < 0.80 % and the fiber aspect ratio, 60 < lf/df < 95. The results in 46 prisms notched of the database formed by 13 studies, showed a considerable influence of the fRi x fu,f ratio with lower variability of around 10%. Thus, through statistical resources, empirical proposals were established to estimate the residual flexural tensile strengths, as a viable and economical alternative to the design project.
20 Jun 2021Submitted to Engineering Reports
21 Jun 2021Submission Checks Completed
21 Jun 2021Assigned to Editor
21 Jul 2021Reviewer(s) Assigned
17 Aug 2021Editorial Decision: Revise Major
19 Nov 20211st Revision Received
19 Nov 2021Submission Checks Completed
19 Nov 2021Assigned to Editor
19 Nov 2021Reviewer(s) Assigned
27 Nov 2021Editorial Decision: Accept