Tasha Aylett

and 4 more

This study presents an analysis of sporadic-E (Es) structures within WACCM-X (the Whole Atmosphere Community Climate Model with thermosphere and ionosphere eXtension), including electrodynamical transport of metallic ions. A set of selection criteria have been developed to identify Es layers in WACCM-X output based on the total metal ion density in each model grid box. These criteria are used to create a climatology of Es, which is compared to Es occurrence rates derived from FORMOSAT/COSMIC-1 (Constellation Observing System for Meteorology, Ionosphere, and Climate) radio-occultation measurements. The novel identification algorithm analyses two-week time slices between altitudes of 90-150km, with Es layer events identified where the three selection criteria are met. Distinct seasonal distributions in Es occurrence were observed that are consistent with previous studies, with peaks during summer and reduced frequencies during winter, alignment of Es with geomagnetic contours, and layers descending in altitude as a function of local time. While discrepancies exist between WACCM-X and COSMIC data (WACCM-X occurrence rates are a factor of ~2 lower than COSMIC-derived occurrence rates at mid-latitudes), highlighting the ongoing challenges in modelling Es layers, this study enhances the modelling capabilities of sporadic Es and deepens our understanding of their formation; it establishes a basis for their enhanced integration into global climate models and facilitates further investigation of Es behaviour under different atmospheric conditions, paving the way to improved prediction of the occurrence of Es.

Gareth Dorrian

and 8 more

A travelling ionospheric disturbance (TID) containing embedded plasma structures which generated Fresnel type asymmetric quasi-periodic scintillations (QPS: Maruyama, 1991) was tracked over a distance of >1200 km across Northern Europe using the LOw Frequency ARray (LOFAR: van Haarlem et al., 2013). Broadband ionospheric scintillation observations of these phenomena are rarely reported in the literature as is the ability to track asymmetric QPS generating plasma structures over such a distance. Asymmetric QPS are characterised by an initial broadband signal fade and enhancement which is then followed by ‘ringing pattern’ interference fringes. These results demonstrate that QPS generating plasma structures can retain their characteristics consistently for several hours, and over distances exceeding 1200 km. A propagation altitude of 110 km was estimated with observations of plasma density modulation in a sporadic-E region detected by the Juliusruh ionosonde, and direct measurements of a wavefront from the TID by co-located medium frequency radar, in which the front is clearly oriented NW-SE, and at an altitude of ~110 km. The TID propagated SW with a calculated velocity of 170 ms-1 and an azimuth of 255°. Periodicity analysis, using the calculated velocity, yielded a spacing between each QPS-generating plasma sub-structure of between 20-40 km. Co-temporal GNSS data were used to establish that these plasma density variations were very small, with a maximum amplitude of no more than +/- 0.05 TECu deviation from the background average.

Chris Watson

and 6 more

The lunar ionosphere is a ~100 km thick layer of electrically charged plasma surrounding the moon. Despite knowledge of its existence for decades, the structure and dynamics of the lunar plasma remain a mystery due to lack of consistent observational capacity. An enhanced observational picture of the lunar ionosphere and improved understanding of its formation/loss mechanisms is critical for understanding the lunar environment as a whole and assessing potential safety and economic hazards associated with lunar exploration and habitation. To address the high priority need for observations of the electrically charged constituents near the lunar surface, we introduce a concept study for the Radio Instrument Package for Lunar Ionospheric Observation (RIPLIO). RIPLIO would consist of a multi-CubeSat constellation (at least two satellites) in lunar orbit for the purpose of conducting “crosslink” radio occultation measurements of the lunar ionosphere, with at least one satellite carrying a very high frequency (VHF) transmitter broadcasting at multiple frequencies, and at least one satellite flying a broadband receiver to monitor transmitting satellites. Radio occultations intermittently occur when satellite-to-satellite signals cross through the lunar ionosphere, and the resulting phase perturbations of VHF signals may be analyzed to infer the ionosphere electron content and high- resolution vertical electron density profiles. As demonstrated in this study, RIPLIO would provide a novel means for lunar observation, with the potential to provide long-term, high-resolution observations of the lunar ionosphere with unprecedented pan-lunar detail.

Joshua James Ruck

and 6 more

Prior to use in operational systems, it is essential to validate ionospheric models in a manner relevant to their intended application to ensure satisfactory performance. For Over-the-Horizon radars (OTHR) operating in the high-frequency (HF) band (3-30 MHz), the problem of model validation is severe when used in Coordinate Registration (CR) and Frequency Management Systems (FMS). It is imperative that the full error characteristics of models is well understood in these applications due to the critical relationship they impose on system performance. To better understand model performance in the context of OTHR, we introduce an ionospheric model validation technique using the oblique ground backscatter measurements in soundings from the Super Dual Auroral Radar Network (SuperDARN). Analysis is performed in terms of the F-region leading edge (LE) errors and assessment of range-elevation distributions using calibrated interferometer data. This technique is demonstrated by validating the International Reference Ionosphere (IRI) 2016 for January and June in both 2014 and 2018. LE RMS errors of 100-400 km and 400-800 km are observed for winter and summer months, respectively. Evening errors regularly exceeding 1,000 km across all months are identified. Ionosonde driven corrections to the IRI-2016 peak parameters provide improvements of 200-800 km to the LE, with the greatest improvements observed during the nighttime. Diagnostics of echo distributions indicate consistent underestimates in model NmF2 during the daytime hours of June 2014 due to offsets of -8° being observed in modelled elevation angles at 18:00 and 21:00 UT.

Ben Boyde

and 7 more

Radio interferometers used to make astronomical observations, such as the LOw Frequency ARray (LOFAR), experience distortions imposed upon the received signal due to the ionosphere as well as those from instrumental errors. Calibration using a well-characterised radio source can be used to mitigate these effects and produce more accurate images of astronomical sources, and the calibration process provides measurements of ionospheric conditions over a wide range of length scales. The basic ionospheric measurement this provides is differential Total Electron Content (TEC, the integral of electron density along the line of sight). Differential TEC measurements made using LOFAR have a precision of <1 mTECu and therefore enable investigation of ionospheric disturbances which may be undetectable to many other methods. We demonstrate an approach to identify ionospheric waves from these data using a wavelet transform and a simple plane wave model. The noise spectra are robustly characterised to provide uncertainty estimates for the fitted parameters. An example is shown in which this method identifies a wave with an amplitude an order of magnitude below those reported using GNSS TEC measurements. Artificially generated data are used to test the accuracy of the method and establish the range of wavelengths which can be detected using this method with LOFAR data. This technique will enable the use of a large and mostly unexplored dataset to study travelling ionospheric disturbances over Europe.
Ground scatter (GS) echoes in Super Dual Auroral Radar Network (SuperDARN) observations have been always expected to occur under high-enough electron density in the ionosphere providing sufficient bending of HF radio wave paths toward the ground. In this study we provide direct evidence statistically supporting this notion by comparing the GS occurrence rate for the Rankin Inlet SuperDARN radar and the F region peak electron density NmF2 measured at Resolute Bay by the CADI ionosonde and incoherent scatter radars RISR-N/C. We show that the occurrence rate increases with NmF2 roughly linearly up to about ~4·1011 m-3, and the trend saturates at larger NmF2. One expected consequence of this relationship is correlation in seasonal and solar cycle variations of the GS echo occurrence rate and NmF2. GS occurrence rates for a number of SuperDARN radars at middle latitudes, in the auroral zone and in the polar cap are considered separately for daytime and nighttime. The data indicate that the daytime occurrence rates are maximized in winter and nighttime occurrence rates are maximized in summer for middle latitude and auroral zone radars in the Northern Hemisphere, consistent with the Winter Anomaly (WA) phenomenon. The effect is most evident in the North American and Japanize sectors, and the quality of WA signatures deteriorates in the European and, especially, in the Australian sectors. The effect does not exist in the South American sector and in the polar caps of both hemispheres.