Open source in-situ environmental sensor hardware continues to expand across the geosphere to a variety of applications. These systems typically perform three fundamental tasks: sample sensors at a specified time or period, save data onto retrievable media, switch power to components on and off in between sample cycles to conserve battery energy and increase field operation time. This is commonly accomplished through integrating separate off-the-shelf components into the desired system such as: power relays, SD card hardware, Real-Time Clocks (RTCs), and coin cell batteries. To enable faster prototyping, the Openly Published Environmental Sensing Lab abstracted all of these requirements into a single PCB that can be dropped into any project to achieve these commonly-required capabilities. The hardware is laid out in a “Feather” form factor, a popular configuration in the open-source hardware community, to easily mate with other industry standard products. The onboard RTC acts as an alarm clock that wakes a user-attached micro controller from low-power sleep modes in between sample cycles. By integrating all these components into a single PCB, we save cost while significantly reducing physical system size. The design as well as a suite of code functions that enable the user to configure all the Hypnos board features are detailed. For more information, please visit open-sensing.org/projects.

Increasing agricultural demand for fresh water resources in the face of a changing climate requires improved irrigation management solutions to maximize resource efficiency while maintaining crop yield and quality. Soil water deficits can significantly reduce plant growth and development, dictating the quantity and quality of the crop. While plant-based measures of water deficits are considered to be the best measures of water stress, current methods for achieving precise stress measurements are time-consuming and inefficient. Dendrometers are one plant-based tool that have shown potential to improve irrigation management in high-value woody perennial crops. High-precision dendrometers continuously measure small fluctuations (± 1 micron) in stem diameter throughout the day, which directly correlates to water stress. However, currently available dendrometers are expensive, have mechanical hysteresis, and are subject to mechanical and environmental issues such as material expansion; weather and animal disruptions; and bulky, invasive design. The dendrometer created at the OPEnS Lab - tailored for grapevines - alleviates these key failure points through the use of zero-thermal expansion carbon fiber, spring tension, and a linear magnetic encoder. The design is also significantly less expensive than that of the competition, costing around $200 as opposed to $1000. Mass deployment of these automated dendrometers has the potential to provide a continuous picture of vineyard water stress at the whole-block level, thus providing valuable decision support for vineyard irrigation management. Follow the project at open-sensing.org/projects.

Increasing agricultural demand for freshwater in the face of a changing climate requires improved irrigation management to maximize resource efficiency. Soil water deficits can significantly reduce plant growth and development, directly impacting crop quantity and quality. Dendrometers are a plant-based tool that have shown potential to improve irrigation management in high-value woody perennial crops (e.g. trees and vines). A dendrometer continuously measures small fluctuations in stem diameter; this has been directly correlated to water stress. While plant-based measures of water deficits are the best indication of water stress, current dendrometers are imprecise due to mechanical hysteresis and thermal expansion. The high-precision dendrometer created at the OPEnS Lab alleviates these key failure points using zero-thermal expansion carbon fiber, zero friction via a spring tensioning approach, and a linear magnetic encoder. The device achieves 0.5-micron resolution, and thermal fluctuations are less than 1 micron over diurnal swings of 25°C. The cost of the device varies with build quantity; parts are $200 - $450 each and assembly requires 6 to 12 hours per system. Dendrometers are currently being deployed with telemetry based on LoRa, which is under evaluation. Without solar charging and telemetry, the battery is sufficient for over two years of operation. Mass deployment of these automated dendrometers has the potential to provide a continuous record of water stress driven changes in stems, providing valuable decision support for irrigation management.