Elastic properties of rocks in subduction zones are indicators of stress states and play important roles in earthquake nucleation. We measured elastic properties of core samples taken from Susaki area in the Shimanto accretionary complex, SW Japan, which experienced the depth condition of the seismogenic zone. We found that the samples have higher P- and S-wave velocities of 5.4-5.8 km/s and lower porosities of 1-2.5 % than other sedimentary rocks in the Shimanto accretionary complex. This may be caused by tight contacts among grains due to pressure solution processes according to microstructural observations. Comparison with seismological observations in the present Nankai Trough indicated that the samples correspond to the hanging wall rocks of the megasplay fault where now a high velocity body is resolved. We further considered velocity-porosity relation using both the samples in this study and the drilled samples from the Nankai Trough, and proposed a model explaining from low to high porosities that is applicable to shallow to deep depths toward the seismogenic zone. The obtained elastic properties provided a critical nucleation length for an earthquake along the plate boundary fault of ~0.5 m. Material and structural heterogeneities below this length scale have the potential to modulate earthquake nucleation processes and future studies on this length scale will be necessary to bridge between laboratories and natural conditions.

Volcanic glass and its mixture with smectite are commonly observed in shallow parts of subduction zones. As volcanic glass layers often act as a glide plane to induce mass transportation such as submarine landslides, and because its alteration product, smectite, is one of the frictionally weakest geological materials, the frictional characteristics of volcanic glass-smectite mixtures are important for fault slip behavior in shallow parts of subduction zones. We performed a series of friction experiments on volcanic glass-smectite mixtures with different smectite contents at various velocity conditions from 10 μm/s to 1 m/s under an effective normal stress of 5 MPa and pore pressure of 10 MPa. In general, friction coefficients negatively depend on the smectite content at any velocity tested. We found that samples with smectite contents of 15-30 % showed a drastic slip-weakening behavior at intermediate velocities of 1-3 mm/s with a characteristic slip displacement of ~0.1 m. Finite element method modeling shows that thermal pressurization does not contribute to the observed weakening behavior. We propose that gouge fluidization or compaction-induced pore pressure increase may be the cause of the weakening. The slip-weakening behavior at intermediate velocities enlarges a critical nucleation length for frictional instability to 1-30 km, or prevent acceleration to seismic slip velocities. Therefore, gouges with minor amount of clay, such as subducting volcanic ash layers, may contribute to the occurrence of the at shallow depths in subduction zones.

Nucleation of earthquake slip at the plate boundary fault (décollement) in subduction zones has been widely linked to the frictional properties of subducting sedimentary facies. However, recent seismological and geological observations suggest that the décollement develops in the subducting oceanic crust in the depth range of the seismogenic zone, at least in some cases. To understand the frictional properties of oceanic crustal material and their influence on seismogenesis, we performed hydrothermal friction experiments on simulated fault gouges of altered basalt, at temperatures of 100-550 ℃. The friction coefficient (μ) lies around 0.6 at most temperature conditions but a low μ down to 0.3 was observed at the highest temperature and lowest velocity condition. The velocity dependence of μ, a−b, changes with increasing temperature from positive to negative at 100-200 ºC and from negative to positive at 450-500 ºC. Compared to gouges derived from sedimentary facies, the altered basalt gouge showed potentially unstable velocity weakening over a wider temperature range. Microstructural observations and microphysical interpretation infer that competition between dilatant granular flow and viscous compaction through pressure-solution creep of albite contributed to the observed transition in a−b. Alteration of oceanic crust during subduction produces fine grains of albite and chlorite through interactions with interstitial water, leading to reduction in its frictional strength and an increase in its seismogenic potential. Therefore, shear deformation possibly localizes within the altered oceanic crust leading to a larger potential for the nucleation of a megathrust earthquake in the depth range of the seismogenic zone.