We present an analysis of the performance data of a monitored PV system onboard a light commercial electric vehicle during parking and driving conditions. The PV system’s nominal power is 2180 WP with flat silicon modules on the vehicle’s roof, rear, left, and right sides, as well as other electronic components needed to charge the vehicle’s high-voltage (HV) battery. The analysis indicated that after 488.92 hours of operation, the modules mounted on the vehicle roof produced 133.32 kWh of electricity during parking compared to 15.4, 30.67, and 22.99 kWh for the modules mounted on the rear, left, and right sides, respectively. During the trips, after 31.99 hours of operation, 6.12, 0.68, 1.08, and 1.86 kWh of electricity were produced by the modules on the roof, rear, left, and right sides, respectively. The overall system efficiency was in the 60-65 % range. The aggregated usable electricity reaching the HV battery after multiple conversion stages generated by the system at the two parking locations was 129.39 kWh. PV electricity generated at the two parking locations enabled a range extension of approximately 530 km, which is 30% of the total distance driven during the measurement period between April and July 2021.

Photovoltaics (PV) in onboard vehicle applications adds weight to an electric vehicle (EV), increasing the overall energy consumption. Although the added PV system weight (1.5– 40 kg) is small compared to the vehicle weight (1500–2200 kg), the power generated by PV (55–700 W) is also very small com- pared to the power needed (up to 80–285 kW) to propel an EV, making the effect of additional PV system weight on energy con- sumption a non-trivial topic to analyze. We present a method to study the impact of vehicle onboard PV weight on the energy balance of EVs for different Vehicle-added PV (VAPV) and vehi- cle-integrated PV (VIPV) configurations with eight different PV technologies, using data from vehicle onboard measurement campaigns and simulations. Simulations are carried out for the driving phase of two electric cars (medium and large passenger cars). Our method calculates the energy consumption attributa- ble to the added PV system weight (0.05–1.4 Wh/km) and PV energy yield (0.12–3.12 Wh/km) for a selection of trips. The re- sults of these simulations are expressed through a newly intro- duced parameter called “onboard PV yield factor”, where posi- tive values indicate a net energy gain and negative values indicate a net energy loss of the onboard PV system. Our results show that the onboard PV yield factor for a VAPV configuration can range between -69.1 and 86.9 %, and for a VIPV configuration, between 77.2 and 89.7 %.